If the operation is normal, you may put the cash dispenser in service. If no jam is located, remove the first note from the cassette. Contact host processor D00A1 FS omitted (after available balance) Verify all programming. Remove jammed currency. 2. this content
Enter the management functions and configure the multiple amount parameter. Error Code: 203 Description: SPED keypad is not replying to main board. Inspect all cables for damage. Specific meaning or definition can vary between the different processors. http://atmequipment.com/Error-Codes
D0067 Capture card at the terminal (requires card be picked up at ATM only). Reset the dispenser and try to resend the command that caused the error code. It the error clears put the cash dispenser back in service.
This error code will cause the cash dispenser to go "Out of Service". You may need to remove the printer to clear jams. Otherwise service to cassette or dispenser may be required. Atm Error Code 3-da000(20) If the error clears, put the cash dispenser in service. 6.
C009F 3Cassette misfeed error Check if notes available in cassette C00AB Notes detected before initalizing Clear notes from dispenser. Hyosung Atm Error Codes Make sure that all cables are securely fastened to their termination points. Recommended Action: This error code will occur only in cash dispensers running ACS terminal software. CDU Board dropped Firmware C0047 Feed error This error occurs when the dispenser attempts to pull a bill from the cassette and is unsucessfull before the dispenser times out.
If the error persists, the vault assembly may need to be removed to inspect / access the cash tray sensors. Hyosung Error Codes Modem response was good, but operation was not performed. 2. Verify that the diverter moves freely. 3. When the note is stuck in the note transport sensor. 2.
If error is persistent, modem may be defective. https://www.nasatm.com/error_codes/code/113/ Verify that the diverter moves freely and is not binding. Triton Atm Error Codes Verify that version of Mini-Bank Software matches host processor. Atm Error Code 3-da001 This is a warning message.
Replace the dispensing mechanism. news Remove any jammed bills from the dispenser, if no bills are present try using compressed air to clean the dispenser (a sensor may be blocked by dust). Error Code: 155 Description: Electronic journal modify record failure. Error Code: 48 (30h) Description: Reject rate exceeded. Error Code 3 Da012 00
Recommended Action: This is a timing wheel or timing wheel sensor error.. 1. Inspect the note diverter in the note transport module. D0075 Number of PIN tries exceeded Code reported by host processor. http://wiicentre.com/error-code/triton-atm-error-code-101.html The primary reason for this is a bill which bounces back from the cash tray (sometimes from a customers fingers).
C004D Cash cassette not properly set Reset the cassette, check position of microswitch on right rear wall of cassette bay in the dispenser. Atm Error Codes List is a registered ISO of MetaBank, Storm Lake IA 50588 Shopping Cart Home (888) 225-9184 Call Today! Install the cassette.
Error Code: 32 (20h) Description: Good operation Recommended Action: No action required. If the error clears, put the cash dispenser back in service. Check that the denomination in Transaction setup matches the actual denomination loaded. Atm Error Code 3-da000(60) If no bills are present try using compressed air to clean the dispenser (a sensor may be blocked by dust).
Enter the management functions and complete the print journal command. Replace the power supply if necessary. Use the diagnostic functions or NMD test software to determine if a note feeder has a faulty or dirty sensor. check my blog belts, gears, cables, or sensors).
Clear the error. Verify that the DC voltages supplied to the dispensing mechanism are correct. Otherwise try the reset button or have the printer serviced. Make sure the shelf that the dispenser is mounted on is level and seated at all four corners. 3.
Error Code: 139 Description: Printer controller not responding to commands. Contact host processor D009F FS omitted (after system trace audit number) Verify all programming. This failure may be caused by a blockage in the transport path between the Note Feeder and the note qualifier, or if a document passes through the note qualifier unseen. If error is persistent the dispenser may require service.
Verify the blue lever on the left side of the printer in the print position. If these actions have no effect, replace the dispensing mechanism. C0014 CDU sensor is tripped Similar to the COO11 error, this would indicate a bill jam close to the exit of the CDU or near the reject bin. This is not an error in particular, but a simple warning that someone was locally on-site at the ATM, and used its Operator Function menu.
Reset the cash dispenser.